Effect of planing on warp in Scots Pine (Pinus sylvestris)

Publikation: Forskning - peer-reviewKonferensartikel i tidskrift

If a sawn board or plank that is warped after drying is being planed, the feed rollers and the pressure elements will more or less straighten the wood during planing. However, when the pressure is released, some degree of warp will recur since the wood will spring back. With a large amount of straightening, only the cross-sectional dimensions of the wood should be affected by the planing operation, leaving warp unchanged, while a small amount of straightening should have a larger impact on warp. The objective of this study was to evaluate how warp is affected by planing in an industrial planer with standard configuration. A total of 20 pine planks with the dry target dimension 50 mm×150 mm were selected, of which half were severely warped. The worst twist, crook and bow per two metres and maximum cup were measured both before and after planing.
The planer in the experiment had different impacts on the different warp types. For the individual planks, twist was reduced by 25% and crook was reduced by about 20% on average. Although bow decreased for half of the planks, the total average change for individual planks was a slight increase. Cupping practically vanished.
SpråkEngelska
TidskriftWood Material Science and Engineering
Publiceringsdatum2012
Volym7
Tidskriftsnummer3
Sidor154-161
Sidantal8
ISSN1748-0272
DOI-länkar
StatusPublicerat

Konferens

KonferensInternational Wood Machining Seminar
Nummer20
LandSverige
OrtSkellefteå
Period07/06/1110/06/11
Internetadresshttp://www.ltu.se/research/subjects/Trateknik/Konferenser/20th-International-Wood-Machining-Seminar

Evenemang (konferens etc.)

International Wood Machining Seminar

jun. 07 2011 - jun. 10 2011

Skellefteå, Sverige

Evenemang (konferens etc.): Konferens